Who To Repair A Ford Steering Wheel Crack
Steering Wheel Restoration
You've spent countless hours on bodywork and paint, your car's engine is spotless, and the interior looks perfect...well, except for that cracked steering bicycle. If you're in that situation, you have several options: live with the cracked steering wheel, effort to locate a expert used steering cycle, purchase a reproduction or aftermarket steering wheel, or repair your existing steering wheel. For many, locating a good used steering wheel is difficult, and reproduction steering wheels (if bachelor) are pricey. This leaves you with the options of either living with a cracked steering wheel, or repairing the existing steering wheel.
Repairing a cracked hard plastic or rubber steering bicycle is a lot easier than you might think. To make the job even easier, Eastwood offers several steering wheel restoration kits that include detailed instructions.
To get started, yous'll first need to remove the steering bike, and make clean it with dishwashing detergent and water. Afterward y'all've washed information technology, spray with PRE Painting Prep to remove oily residual that may accept come from your skin. For whatever cracks, you will want to use a triangle file to "5" the crack. Tip: a Dremel-style tool besides works well. This volition allow y'all to completely fill the crack with the PC-seven Epoxy. Mix the PC-7 post-obit the directions on the dorsum of the can. Slightly overfill the crack with the PC-vii. (Tip: wet your finger with water to smoothen out the PC-7.) Let the PC-7 to dry for 24 hours.
After the PC-7 has thoroughly dried, start smoothing it with 240-grit sandpaper, and cease with 320-grit sandpaper. Spray information technology again with PRE to clean the surface. Exist certain to non handle the steering wheel with your blank hands, as this may contaminate the surface with oils from your skin. Y'all are at present ready to utilise a primer.
 | Use Gray Self-Etch Primer to utilize several light coats to smoothen the surface. One time it dries, you're ready to utilize your topcoat. The cocky-etching primer creates a great base for nearly whatever topcoat finish (epoxies are not recommended). Our vinyl interior dyes work well as topcoats over the Self-Etching primer. Here is a "before" picture of a steering wheel that we recently restored. |
| This image shows the cracks the steering wheel had. This steering wheel had been repainted by a previous possessor, then we sanded the finish off to get to the blank prophylactic. Note that the old paint was hiding the extent of the crack. Once nosotros removed the pigment, we could see the full extent of the harm, Nosotros "5"-ed the cleft to accept the PC-seven putty. |  |
 | This image shows i of the cracks filled in with the PC-7, and then sanded with 240-grit and 320-grit sandpaper. Next, the steering wheel was wiped down with PRE and primed. |
| Here is the finished product. After the steering wheel was primed, it was painted with ivory white base coat, and then top-coated with a Urethane Clear Coat. |  |
Source: https://www.eastwood.com/steering-wheel-restoration-steering-wheel-repair-tips-from-eastwood
Posted by: buckinghamdefe1965.blogspot.com
0 Response to "Who To Repair A Ford Steering Wheel Crack"
Post a Comment